MIKROTIK - MLAG By CLI

Configuring MLAG via CLI

To configure MLAG via CLI on a Mikrotik router, follow these steps:

1. Connect to the Mikrotik router via the CLI.

2. Create a new bridge by using the command:

  
   /interface bridge add name=bridge1
   

3. Add the ports that you want to aggregate to the bridge by using the command:

  
   /interface bridge port add bridge=bridge1 interface=ether1
   /interface bridge port add bridge=bridge1 interface=ether2
   

4. Configure the ports as a LACP (Link Aggregation Control Protocol) port by using the command:

  
   /interface lacp set [find where bridge=bridge1] lacp-enabled=yes
   

5. Verify the configuration by using the command:

  
   /interface bridge port print
   

</nowiki>