ESXI - Base Commands: Difference between revisions
From Wiki.IT-Arts.net
imported>Z No edit summary |
No edit summary |
||
| Line 64: | Line 64: | ||
esxcli network ip dns server list | esxcli network ip dns server list | ||
DNSServers: 80.67.169.12, 80.67.169.40</nowiki> | DNSServers: 80.67.169.12, 80.67.169.40</nowiki> | ||
== Show VLAN == | |||
Type the following command in the console : | |||
<nowiki> | |||
esxcfg-vswitch -l</nowiki> | |||
Alternatively, in the vMA appliance, type the vicfg-vswitch command—the output is similar for both commands: | |||
<nowiki> | |||
vicfg-vswitch –l</nowiki> | |||
Revision as of 10:16, 9 June 2024
Dealing with EsXi CLI...
Show Routes
esxcli network ip route ipv4 list
Show Interfaces and Subnet Masks
esxcli network ip interface ipv4 get
Netcat in EsXi
The 'nc' or Netcat command in Linux is a networking utility for reading from and writing to network connections using TCP or UDP :
nc -w <timeout-in-seconds> -z <destination-ip> <destination-port>
Show Interfaces MAC Addresses
esxcli network ip interface list
Show ARP Table
esxcli network ip neighbor list
Show Interfaces
The command below will show the physical status of the interface including if the link is up, the MAC address, and speed of the interfaces :
esxcfg-nics -l
Show DNS Search Domain
esxcli network ip dns search list DNSSearch Domains: example.net
Show DNS Server List
esxcli network ip dns server list DNSServers: 80.67.169.12, 80.67.169.40
Show VLAN
Type the following command in the console :
esxcfg-vswitch -l
Alternatively, in the vMA appliance, type the vicfg-vswitch command—the output is similar for both commands:
vicfg-vswitch –l
