MIKROTIK - MLAG By CLI: Difference between revisions
From Wiki.IT-Arts.net
imported>Z No edit summary |
imported>Z |
||
| Line 11: | Line 11: | ||
2. Create a new bridge by using the command: | 2. Create a new bridge by using the command: | ||
<nowiki> | <nowiki> | ||
/interface bridge add name=bridge1</nowiki> | /interface bridge add name=bridge1</nowiki> | ||
3. Add the ports that you want to aggregate to the bridge by using the command: | 3. Add the ports that you want to aggregate to the bridge by using the command: | ||
<nowiki> | <nowiki> | ||
/interface bridge port add bridge=bridge1 interface=ether1 | /interface bridge port add bridge=bridge1 interface=ether1 | ||
/interface bridge port add bridge=bridge1 interface=ether2</nowiki> | /interface bridge port add bridge=bridge1 interface=ether2</nowiki> | ||
| Line 22: | Line 22: | ||
4. Configure the ports as a LACP (Link Aggregation Control Protocol) port by using the command: | 4. Configure the ports as a LACP (Link Aggregation Control Protocol) port by using the command: | ||
<nowiki> | <nowiki> | ||
/interface lacp set [find where bridge=bridge1] lacp-enabled=yes</nowiki> | /interface lacp set [find where bridge=bridge1] lacp-enabled=yes</nowiki> | ||
5. Verify the configuration by using the command: | 5. Verify the configuration by using the command: | ||
<nowiki> | <nowiki> | ||
/interface bridge port print</nowiki> | /interface bridge port print</nowiki> | ||
Latest revision as of 13:23, 21 January 2023
Configuring MLAG via CLI
To configure MLAG via CLI on a Mikrotik router, follow these steps:
1. Connect to the Mikrotik router via the CLI.
2. Create a new bridge by using the command:
/interface bridge add name=bridge1
3. Add the ports that you want to aggregate to the bridge by using the command:
/interface bridge port add bridge=bridge1 interface=ether1 /interface bridge port add bridge=bridge1 interface=ether2
4. Configure the ports as a LACP (Link Aggregation Control Protocol) port by using the command:
/interface lacp set [find where bridge=bridge1] lacp-enabled=yes
5. Verify the configuration by using the command:
/interface bridge port print
